Mazda 6 Service Manual: Thermostat
THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
5. Remove the washer tank.
6. Remove the P/S oil pump.
Note
- Remove the P/S oil pump with hoses and pipe still connected.
7. Remove in the order indicated in the table.
8. Install in the reverse order of removal.
9. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
10. Inspect the engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION.)
THERMOSTAT INSPECTION
Inspect the thermostat for the following.
- Closed valve in room temperature
- Opening temperature and lift of the valve
- If not as specified, replace the thermostat.
Radiator
RADIATOR REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
3. Remove the cooling fan. (See COOLING FAN REMOVAL/INSTALLATI ...
Water pump
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) (See
ENGINE COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the d ...
Other materials:
Mazda 6 Service Manual: Traction Control System (TCS)
The Traction Control System (TCS) enhances traction and safety by controlling
engine torque and braking. When the TCS detects driving wheel slippage, it lowers
engine torque and operates the brakes to prevent loss of traction.
This means that on a slick surface, the engine adjusts automatically ...
Mazda 6 Service Manual: Fuel tank removal/installation
Warning
Repairing a fuel tank that has not been properly steam cleaned can
be dangerous. Explosion or ire may cause death or serious injury. Always
properly steam clean a fuel tank before repairing it.
Fuel line spills and leakage are dangerous. Fuel can ignite and
cause serious injur ...