Mazda 6 Service Manual: Cooling system

Oil pump

OIL PUMP REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Drain the engine oil. (See ENGINE OIL REPLACEMENT.) 3. Remove the oil pan. (See OIL PAN REMOVAL/INSTALLATION.) 4. Remove ...

Location index

...

Other materials:

Mazda 6 Service Manual: Engine tune-up
IGNITION TIMING INSPECTION Note Ignition timing is not adjustable. Ignition timing verification requires WDS or equivalent. 1. Turn off the electrical loads. 2. Warm up the engine as follows. (1) Start the engine. (2) Maintain the engine speed at approx. 3,000 rpm until the cooli ...

Mazda 6 Service Manual: Rear shock absorber removal/installation
Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropri ...