Mazda 6 Service Manual: Water pump
1. Disconnect the negative battery cable.
2. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) (See ENGINE COOLANT REPLACEMENT.)
3. Loosen the water pump pulley bolt to remove the drive belt. (See DRIVE BELT REPLACEMENT.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Refill the engine coolant. (See ENGINE COOLANT REPLACEMENT.)
7. Inspect the engine coolant leakage. (See ENGINE COOLANT LEAKAGE INSPECTION.)
Thermostat
THERMOSTAT REMOVAL/INSTALLATION
1. Remove the plug hole plate.
2. Disconnect the negative battery cable.
3. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
4. Remove the drive bel ...
Fan motor
COOLING FAN REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the shroud panel. (See SHROUD PANEL REMOVAL/INSTALLATION.)
3. Remove the A/C pipe stay.
4. Remove the ATX pipe ...
Other materials:
Mazda 6 Service Manual: How to use AUX mode
1. Select the icon on the home
screen to display the Entertainment screen.
2. Select to switch to the AUX
mode. The following icons are displayed in the lower part of the center display.
NOTE
If a device is not connected to the auxiliary jack, the mode does not
switch to the AUX mod ...
Mazda 6 Service Manual: Woofer inspection
1. Inspect for continuity between the audio amplifier connector terminals and
woofer connector terminals using an ohmmeter.
If not as specified, replace the related wiring harnesses.
2. Verify that there is battery positive voltage at the woofer connector
terminal A (4SD) or C (5HB) u ...