
Foreword
No.1 insufficient air (or no air) blown from ventsMazda 6 Service Manual: Pcm configuration
1. Connect the WDS to DLC-2.
2. Set up the WDS (including the vehicle recognition.)
3. Select Module programming.
4. Select Programmable module installation.
5. Select PCM and perform procedures according to directions on the WDS
screen.
Note
If PCM CONFIGURATION is successful, the PCM ...
Mazda 6 Service Manual: Evaporator temperature sensor inspection
1. Turn the AUTO switch on.
2. Set the temperature control at MAX COLD (Turn the left).
3. Turn the A/C switch.
4. Set the RECIRCULATE mode.
5. Close all doors and windows.
6. Wait for 5 minutes.
7. Remove the glove compartment.
8. Disconnect the evaporator temperature sensor.
9. Measure t ...