4SD
1. Remove the fasteners.
2. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks.

3. Remove the trunk end trim.
4. Install in the reverse order of removal.
5HB
1. Pull the trunk end trim upward, then disengage clips A, pins B, and hooks.

2. Remove the trunk end trim.
3. Install in the reverse order of removal.
Trunk lid trim removal/installation
Liftgate upper trim removal/installationMazda 6 Service Manual: Floor covering
FRONT FLOOR COVERING REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION.)
3. Remove the rear seat.
4. Remove the front scuff plates.
5. Remove the rear scuff plates.
6. Remove the console.
7. Remove the front side tri ...
Mazda 6 Service Manual: Voice Recognition
In this section, the basic operation of the voice recognition is explained.
Activating Voice Recognition
Press the talk button.
Ending Voice Recognition
Use one of the following methods:
Press the hang-up button.
Say, “Cancel”.
Operate the commander switch or the center display (only ...