Mazda 6 Service Manual: Two-step down function operative/non-operative switching procedure

Mazda 6 Service Manual / Body / Power window system / Two-step down function operative/non-operative switching procedure

Note

By following the procedure below, the two-step down function is switched to non-operative when it is operative, and to operative when it is non-operative.

Initial setting

Note A driver side window will not fully close automatically under following the conditions: - The battery has been disconnected during vehicle maintenance or for other reasons. - Th ...

Door glass position change procedure

Note After performing the following procedure, verify that the two-step down function operates normally and the door glass position has changed. If the two-step down function does not operat ...

Other materials:

Mazda 6 Service Manual: Transaxle oil replacement
1. Remove the drain plug with the washer. 2. Drain the oil into a suitable container. 3. Install a new washer and the drain plug. Tightening torque 40-58 N·m {4.0-6.0 kgf·m, 29-43 ft·lbf} 4. Remove the oil level plug with washer and add nthe specified amount and type of oil through t ...

Mazda 6 Service Manual: Power window motor removal/installation
1. Disconnect the negative battery cable. 2. Remove the front door trim or rear door trim. 3. Disconnect the power window motor connector. 4. Remove the bolts. 5. Remove the power window motor from the power window regulator drum. 6. Install in the reverse order of removal. Note When ins ...