Mazda 6 Service Manual: Units

Conversion to SI Units (Système International d'Unités)
- All numerical values in this manual are based on SI units. Numbers shown
in conventional units are converted from these values.
Rounding Off
- Converted values are rounded off to the same number of places as the SI
unit value. For example, if the SI unit value is 17.2 and the value after
conversion is 37.84, the converted value will be rounded off to 37.8.
Upper and Lower Limits
- When the data indicates upper and lower limits, the converted values are
rounded down if the SI unit value is an upper limit and rounded up if the SI
unit value is a lower limit. Therefore, converted values for the same SI
unit value may differ after conversion. For example, consider 2.7 kgf/cm2 in
the following specifications:
210-260 kPa {2.1-2.7 kgf/cm2, 30-38 psi}
270-310 kPa {2.7-3.2 kgf/cm2, 39-45 psi}
- The actual converted values for 2.7 kgf/cm2 are 264 kPa and 38.4 psi. In
the first specification, 2.7 is used as an upper limit, so the converted
values are rounded down to 260 and 38. In the second specification, 2.7 is
used as a lower limit, so the converted values are rounded up to 270 and 39.
Basic flow of troubleshooting
DTC troubleshooting flow (on-board diagnostic)
Diagnostic trouble codes (DTCs) are important hints for repairing
malfunctions that are difficult to simulate.
Perfo ...
Other materials:
Mazda 6 Service Manual: Inspection of dtcs for condition detection mode
Note
The cruise set indicator light will illuminate for 3 seconds,
when condition detection mode is on.
If the RESUME/ACCEL switch on the cruise control switch is
malfunctioning, the cruise set indicator light will not give a correct
indication when you inspect the system.
1. Drive ...
Mazda 6 Service Manual: Drive belt auto tensioner inspection
1. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
2. Verify that the drive belt auto tensioner moves smoothly in the
operational direction.
Replace the drive belt auto tensioner if necessary.
3. Turn the drive belt auto tensioner pulley by hand and verify that it
rotates smoothly ...