Mazda 6 Service Manual: Battery recharging
Warning
- Keep any flammable away from the battery, otherwise evaporated gas of the battery fluid may catch fire, and cause serious injury or death.
Caution
- When removing the battery, disconnect the negative battery cable first and install it last to prevent damage to electrical components or the battery.
1. Place a battery in a pan of water to prevent it from overheating.
2. The water level should come up about halfway on the battery.
3. Remove the battery plugs while charging the battery.
4. Keep water off the top of the battery.
Caution
- To prevent damage to electrical components or the battery, turn all accessories off and stop the engine before performing maintenance or recharging the battery.
5. Connect a battery charger to the battery.
6. Adjust the charging current as follows.
Battery inspection
Battery
Inspect the battery in the following procedure.
Test load chart
Battery positive voltage with load
Back-up Current
1. Verify that the engine switch is at OFF and that the key has be ...
Generator removal/installation
Warning
When the battery cables are connected, touching the vehicle body with
generator terminal B will generate sparks. This can cause personal injury, fire,
and damage to the electrical comp ...
Other materials:
Mazda 6 Service Manual: Direct Mode
Direct mode can be used for temporarily switching gears by operating the steering
shift switch while the vehicle is being driven with the selector lever in the D
range.
While in direct mode, the D and M indication illuminate and the gear position
in use is illuminated. Direct mode is canceled ...
Mazda 6 Service Manual: Gate operator/Canadian Programming
Canadian radio-frequency laws require transmitter signals to “time-out” (or quit)
after several seconds of transmission — which may not be long enough for HomeLink
to pick up the signal during programming. Similar to this Canadian law, some U.S.
gate operators are designed to “time-out ...