Mazda 6 Service Manual: Clutch release collar inspection
Caution
- Cleaning the clutch release collar with cleaning fluids or a steam cleaner can wash the grease out of the sealed bearing.
Turn the collar while applying force in the axial direction.
- If the collar sticks or has excessive resistance, replace the clutch release collar.
Clutch disc inspection
1. Using vernier calipers, measure the thickness of the lining at a rivet
head on both sides.
Replace the clutch disc if its thickness is less than the minimum.
Thickness
0.3 mm {0.012 i ...
Flywheel
FLYWHEEL INSPECTION
1. Install a dial gauge on the cylinder block.
2. Measure the flywheel runout using a dial indicator.
If the runout is excessive, replace the flywheel.
Runout
0.1 m ...
Other materials:
Mazda 6 Service Manual: Intermittent concern troubleshooting
Vibration Method
1. If malfunction occurs or becomes worse while driving on a rough road or
when engine is vibrating, perform the steps below.
Note
There are several reasons vehicle or engine vibration could cause
an electrical malfunction. Some of the things to check for are:
...
Mazda 6 Service Manual: New standards
Following is a comparison of the previous standard and the new standard.
#1 : Diagnostic trouble codes depend on the diagnostic test mode
#2 : Controlled by the PCM
#3 : In some models, there is a fuel pump relay that controls pump speed.
That relay is now called the fuel pump relay (s ...