1. Disconnect the negative battery cable.
2. Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.)
3. Remove the steering wheel. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION.)
4. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
5. Remove the clock spring. (without DSC) (See CLOCK SPRING REMOVAL/INSTALLATION.)
6. Remove in the order indicated in the table.
7. Install in the reverse order of removal.
Mazda 6 Service Manual: Intermittent concern troubleshooting
Vibration Method
If malfunction occurs or becomes worse while driving on a rough road or
when engine is vibrating, perform the steps below.
Note
There are several reasons why vehicle or engine vibration could
cause an electrical malfunction. Some of the things to check for:
- ...
Mazda 6 Service Manual: Intake-air system removal/installation
Warning
When the engine and intake-air system are hot, they can badly
burn. Turn off the engine and wait until they are cool before removing the
intake-air system.
Fuel vapor is hazardous. It can easily ignite, causing serious
injury and damage. Always keep sparks and flames away from ...