1. Disconnect the negative battery cable.
2. Remove the rear finisher. (See REAR FINISHER REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Mazda 6 Service Manual: Starting a Flooded Engine
If the engine fails to start, it may be flooded (excessive fuel in the engine).
Follow this procedure:
1. If the engine does not start within five seconds on the first try, wait ten
seconds and try again.
2. Make sure the parking brake is on.
3. Depress the accelerator all the way and hold it ...
Mazda 6 Service Manual: Schedule 2
Chart symbols:
I
: Inspect: Inspect and clean, repair, adjust, fill up, or replace if necessary.
R
: Replace
L
: Lubricate
C
: Clean
T
: Tighten
Remarks:
*1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant other than FL ...