Mazda 6 Service Manual: Drive belt replacement
1. Remove the splash shield (RH).
2. Turn the center of the tensioner pulley clockwise to release tension to the drive belt.
3. Remove the drive belt.
4. Reinstall the drive belt or install a new drive belt.
5. Verify that the drive belt auto tensioner indicator mark does not exceeds the limit. (See DRIVE BELT INSPECTION.)
- If it exceeds the limit, replace the drive belt.
6. Install the splash shield (RH).
Drive belt inspection
Note
Front and water pump drive belt deflection/tension inspection is
not necessary because of the use of the front drive belt auto tensioner.
Front Drive Belt
Verify that the drive belt au ...
Drive belt auto tensioner inspection
1. Remove the drive belt. (See DRIVE BELT REPLACEMENT.)
2. Verify that the drive belt auto tensioner moves smoothly in the
operational direction.
Replace the drive belt auto tensioner if necess ...
Other materials:
Mazda 6 Service Manual: Caliper (front) disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of removal.
Piston Disassembly Note
Caution
Blow the compressed air slowly to prevent the piston from suddenly
popping out.
1. Place a piece of wood in the caliper, then blow compressed air through ...
Mazda 6 Service Manual: Bluetooth® Preparation
Device pairing
To use Bluetooth® audio and Hands-Free, the device equipped with Bluetooth® has
to be paired to the unit using the following procedure. A maximum of seven devices
including Bluetooth® audio devices and hands-free mobile phones can be paired.
NOTE
The Bluetooth® system ma ...