Mazda 6 Service Manual: Dtc c1186, c1266
Caution
- When attaching the tester lead to the ABS (ABS/TCS) HU/CM harnesses connector the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM INSPECTION.)
Diagnostic procedure
Dtc c1148, c1158, c1168, c1178, c1233, c1234, c1235, c1236
Caution
When attaching the tester lead to the ABS (ABS/TCS) HU/CM harness
connector, the SST (49 G066 001) must be used. (See ABS (ABS/TCS) HU/CM
INSPECTION.)
Diagnostic procedure
...
Dtc c1194, c1198, c1210, c1214, c1242, c1246, c1250, c1254, c1400, c1410,
c1957, c1958
Diagnostic procedure
...
Other materials:
Mazda 6 Service Manual: Rear washer hose removal/installation
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Partially peel off the right side mud guard.
4. Remove rear washer hose No.1 from the clips.
5. Remove rear washer hose No.1 and joint pipe A.
6. Remove the A-pillar trim. (See A-PIL ...
Mazda 6 Service Manual: Abs (abs/tcs) hu/cm inspection
1. Disconnect the negative battery cable.
2. Connect the SST between the ABS (ABS/TCS) HU/CM and harness
connector with the ignition switch off.
3. Attach the tester leads to the SST and inspect voltage referring
the table below.
Terminal Voltage Table (Reference)
(Engine is idling, and co ...