Mazda 6 Service Manual: Flasher unit inspection
1. Connect the connector to the flasher unit.
2. Connect the negative battery cable.
3. Measure the voltage at the flasher unit using voltmeter.
- When inspecting terminal F for continuity, disconnect the flasher unit connector.
4. If the value are not as specified in the Terminal Voltage List (Reference), inspect the parts under Action and related wiring harnesses.
5. If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the flasher unit.
Terminal Voltage List (Reference)
Flasher unit removal/installation
1. Disconnect the negative battery cable.
2. Remove the instrument cluster. (See INSTRUMENT CLUSTER REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Inst ...
Running light unit removal/installation
Disconnect the negative battery cable.
2. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in ...
Other materials:
Mazda 6 Service Manual: Starting the Engine
WARNING
Radio waves from the key may affect medical devices such as pacemakers:
Before using the key near people who use medical devices, ask the medical device
manufacturer or your physician if radio waves from the key will affect the device.
NOTE
The key must be carried because the key c ...
Mazda 6 Service Manual: Rear brake (disc) inspection
Brake Judder Repair Hint
1. (See FRONT BRAKE (DISC) INSPECTION.)
Disc Plate Thickness Inspection
Caution
Excessive runout may result if the disc plate is removed from the
vehicle then machined. Machine the disc plate while installed on the
vehicle.
1. Measure the thickness of the dis ...