Disconnect the negative battery cable.
2. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Mazda 6 Service Manual: Heated oxygen sensor (ho2s) inspection
HO2S Voltage Inspection
Note
Perform the following inspection only when directed.
1. Warm up the engine and run it at idle.
2. Disconnect the HO2S connector.
3. Connect the voltmeter test leads to the following HO2S terminals:
HO2S (front and rear)
- (+) leadterminal A
- (-) le ...
Mazda 6 Service Manual: Air mix actuator inspection
1. Connect battery positive voltage to terminal D or F and ground to terminal
F or D of the air mix actuator.
2. Verify that the air mix actuator operates as shown below.
If not as specified, replace the air mix actuator.
e
3. Verify that the resistance between the terminals of the ...