Mazda 6 Service Manual: Running light unit inspection
1. Connect the connector to the running light unit.
2. Connect the negative battery cable.
3. Measure the voltage at the running light unit using voltmeter.
- When inspecting terminal D, H or P for continuity, disconnect the running light unit connector.
4. If the value are not as specified in the Terminal Voltage List (Reference), inspect the parts under Action and related wiring harnesses.
5. If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the running light unit.
Terminal Voltage List (Reference)
Running light unit removal/installation
Disconnect the negative battery cable.
2. Remove the glove compartment. (See GLOVE COMPARTMENT REMOVAL/INSTALLATION)
3. Remove in the order indicated in the table.
4. Install in ...
Other materials:
Mazda 6 Service Manual: Steering angle sensor inspection
With DSC
1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION)
2. Disconnect the steering angle sensor connector.
3. Connect battery positive voltage to terminal A and ground to terminal F of
the steering angle sensor.
4. Turn the steering wheel to the right and left, and verify ...
Mazda 6 Service Manual: Opening the Hood
1. With the vehicle parked, pull the release handle to unlock the hood.
2. Insert your hand into the hood opening, slide the latch lever to the right,
and lift up the hood.
NOTE
The lever is located a little to the left of center when facing the vehicle.
3. Grasp the support rod in the pad ...