Mazda 6 Service Manual: Front map light removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Front Map Light Removal Note
1. Insert a tape-wrapped flathead screwdriver into the gap between the headliner and the front map light.
2. Push the hooks to remove the front map light.
Front map light inspection
1. Remove the front map light. (See FRONT MAP LIGHT REMOVAL/INSTALLATION.)
2. Inspect for continuity between the front map light terminals using an
ohmmeter.
If not as specified, replace the fr ...
Other materials:
Mazda 6 Service Manual: Base removal
1. Remove the rearview mirror.
2. Wind each end of a wire around a bar.
Warning
Using a SST (piano wire) with bare hands can cause injury. Always
wear gloves when using a SST (piano wire).
Note
Use a long sawing action to spread the work over the whole length
of the SST (piano w ...
Mazda 6 Service Manual: Vehicle speedometer sensor (vss) removal/installation
Caution
Water or foreign objects entering the connector can cause a poor
connection or corrosion. Be sure not to drop water or foreign objects on the
connector when disconnecting it.
If foreign materials are stuck to the VSS, disturbance by magnetic
flux can cause sensor output to be ...