Mazda 6 Owners Manual: Fuel-Filler Lid and Cap
WARNING
When removing the fuel-filler cap, loosen the cap slightly and wait for any hissing to stop, then remove it:
Fuel spray is dangerous. Fuel can burn skin and eyes and cause illness if ingested. Fuel spray is released when there is pressure in the fuel tank and the fuel-filler cap is removed too quickly.
Before refueling, stop the engine, and always keep sparks and flames away from the filler neck:
Fuel vapor is dangerous. It could be ignited by sparks or flames causing serious burns and injuries. Additionally, use of the incorrect fuelfiller cap or not using a fuel-filler cap may result in a fuel leak, which could result in serious burns or death in an accident.
Do not continue refueling after the fuel pump nozzle shuts off automatically:
Continuing to add fuel after the fuel pump nozzle has shut off automatically is dangerous because overfilling the fuel tank may cause fuel overflow or leakage. Fuel overflow and leakage could damage the vehicle and if the fuel ignites it could cause a fire and explosion resulting in serious injury or death.
CAUTION
(U.S.A. and Canada)
Always use only a genuine Mazda fuelfiller cap or an approved equivalent, available at an Authorized Mazda Dealer. The wrong cap can result in a serious malfunction of the fuel and emission control systems. It may also cause the check engine light in the instrument cluster to illuminate.
Engine Exhaust (Carbon monoxide)
WARNING
Do not drive your vehicle if you smell exhaust gas inside the vehicle:
Engine exhaust gas is dangerous. This gas contains carbon monoxide (CO), which is
colorless, odorless, and poisonous ...
Fuel-Filler Lid
To open, pull the remote fuel-filler lid release.
To close, press the fuel-filler lid until it locks securely.
...
Other materials:
Mazda 6 Owners Manual: No.9 noise while operating a/c system
Diagnostic procedure
* : If there is gas leakage, air enters into the A/C system. The desiccant
within the receiver/drier absorbs the moisture from the air and becomes
saturated. If the A/C system is used in this condition, the inside of the A/C
compressor will begin to rust due to this ...
Mazda 6 Owners Manual: Front and rear fog light switch inspection
Light switch LH side
1. Remove the light switch. (See LIGHT SWITCH REMOVAL/INSTALLATION.)
2. Inspect for continuity between the light switch terminals using an
ohmmeter.
If not as specified, replace the light switch.
Light switch RH side
1. Remove the light switch. (See LIGHT SWITCH ...