Mazda 6 Service Manual: Headlight cleaner hose removal/installation
1. Remove the front bumper. (See FRONT BUMPER REMOVAL/INSTALLATION)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight cleaner nozzle adjustment
Use a needle or equivalent to adjust the headlight cleaner nozzle so that the
center of fluid properly sprays on the headlight as shown in the figure.
HEADLIGHT CLEANER NOZZLE CLEANING
Clean the ...
Headlight cleaner switch removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Headlight Cleaner Switch Removal Note
1. Insert your hand f ...
Other materials:
Mazda 6 Service Manual: General procedures
PRECAUTION (BRAKES)
Wheels and Tires Removal/Installation
1. The removal and installation procedures for the wheels and tires are not
mentioned in this section. When a
wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}.
Brake Lines Disconnection/Connection
Cautio ...
Mazda 6 Service Manual: Engine coolant temperature (ect) sensor inspection
Note
Perform the following inspection only when directed.
ECT Sensor Resistance Inspection
1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.)
2. Remove the ECT sensor (located above the starter).
3. Place the ECT sensor in water with a thermometer, and heat the water
gra ...