1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Joint Shaft Disassembly Note
Disassemble the joint shaft.
Bearing Disassembly Note
Remove the bearing using the SSTs
.
Dust Seal (Right) Assembly Note
1. Apply grease to the new dust seal lip.
2. Install the new right side dust seal using the SSTs
.
Bearing Assembly Note
Install the new bearing using the SSTs
.
Dust Seal (Left) Assembly Note
1. Apply grease to the new dust seal lip.
2. Install the new left side dust seal using a steel plate and the SSTs
.
Joint Shaft Assembly Note
Assemble the joint shaft using a press and the SST
.
Mazda 6 Service Manual: Rear drain hose removal
1. Remove the headliner.
2. Remove the trunk side trim. (4SD)
3. Remove the trunk side upper trim and trunk side trim. (5HB)
4. Disconnect the rear drain hose from the sunroof frame.
5. Remove the rear drain hose from the clips.
6. Pull the rear drain hose into the room side.
7. Remove the rea ...
Mazda 6 Service Manual: Rear lateral link removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...