Mazda 6 Service Manual: Drive shaft

Wheel hub, hub spindle removal/installation

Caution Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing ...

Joint shaft pre-inspection

1. Verify that the joint shaft is not twisted or cracked. Replace it as necessary. 2. Turn the joint shaft by hand and verify that the bearing rotates smoothly and freely. Replace it as n ...

Other materials:

Mazda 6 Service Manual: Cargo compartment light switch inspection
1. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION) 2. Disconnect the cargo compartment light switch connector. 3. Inspect for continuity between the cargo compartment light switch terminals using an ohmmeter. If not as specified, replace the liftgate lock. ...

Mazda 6 Service Manual: Liftgate removal/installation
Warning Removing the stay damper without supporting the liftgate can be dangerous. The liftgate may fall and injure you. Open the liftgate fully and support it before removing the stay damper. 1. Disconnect the negative battery cable. 2. Remove the liftgate lower upper trim. 3. Press ...