Caution
1. Drain the transaxle oil. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT.) (See TRANSAXLE OIL REPLACEMENT.)
2. Remove the ABS sensor. (See FRONT ABS WHEEL-SPEED SENSOR REMOVAL/INSTALLATION.)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Brake Caliper Component Removal Note
Suspend the caliper aside with wire.
Wheel Hub, Steering Knuckle and Drive Shaft Removal Note
Caution
1. Pull the joint shaft straight out.
2. Install the SST
into the transaxle to hold the side gears after the joint shaft is removed.
Clip Installation Note
1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on installation.
2. After installation, measure the outer diameter. If it exceeds the specification, repeat Step 1 using a new clip.
Outer diameter specification 31.2 mm {1.23 in} max.
Mazda 6 Service Manual: Picture Quality Adjustment
WARNING
Always adjust the picture quality of the rear view monitor while the vehicle
is stopped: Do not adjust the picture quality of the rear view monitor while
driving the vehicle. Adjusting the picture quality of the rear view monitor such
as brightness, contrast, color, and tint while dri ...
Mazda 6 Service Manual: TCS/DSC Indicator Light
This indicator light stays on for a few seconds when the ignition is switched
ON. If the TCS or DSC is operating, the indicator light flashes.
If the light stays on, the TCS, DSC or the brake assist system may have a malfunction
and they may not operate correctly. Take your vehicle to an Auth ...