Mazda 6 manuals

Mazda 6 Service Manual: No.22 no engine braking in hold mode

Mazda 6 Service Manual / Automatic transaxle / Troubleshooting / No.22 no engine braking in hold mode


Diagnostic procedure


No.21 noise occurs at idle when vehicle is stopped in d, s, l ranges, or in r position
...

No.23 transaxle overheats
Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Height Adjustment
Adjust the head restraint so that the center is even with the top of the passenger's ears. To raise a head restraint, pull it up to the desired position. To lower the head restraint, press the stopcatch release, then push the head restraint down. Front outboard seat Rear outboard seat ...

Mazda 6 Service Manual: Center panel module removal/installation
1. Cancel the anti-theft operation. (with anti-theft system) (See ANTI-THEFT SYSTEM.) 2. Disconnect the negative battery cable. 3. Remove the glove compartment. 4. Remove the rear console. 5. Remove in the order indicated in the table. 6. Install in the reverse order of removal. Caution ...

© 2016-2024 Copyright www.mazda6info.net