Mazda 6 Service Manual: No.9 tcs off light stays on more than 4 seconds with ignition switch on

Mazda 6 Service Manual / Braking system / Troubleshooting (abs/tcs/dynamic stability control) / No.9 tcs off light stays on more than 4 seconds with ignition switch on

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harnesses are connected correctly and undamaged.

No.8 brake system warning light stays on more than 4 seconds with ignition switch on

Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact p ...

No.10 tcs does not work correctly

Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Operation
NOTE The engine may not start and security indicator light may illuminate or flash if the key is placed in an area where it is difficult for the system to detect the signal, such as on the dashboard or in the glove compartment. Move the key to a location within the signal range, switch ...

Mazda 6 Service Manual: General procedures
Wheels and Tires Removal/Installation The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf}. Power Steering Components Removal/Installation If any power steeri ...