Mazda 6 Service Manual: Troubleshooting (abs/tcs/dynamic stability control)
- System wiring diagram
- Precaution
- Symptom troubleshooting
- No.1 abs warning light, brake system warning light, tcs off light do not
illuminate with ignition switch on
- No.2 neither abs warning light nor brake system warning lightilluminate with
ignition switch on
- No.3 abs warning light does not illuminate with ignition switch on
- No.4 brake system warning light does not illuminate with ignition switch on
- No.5 tcs off light does not illuminate with ignition switch on
- No.6 both abs warning light and brake system warning light stay on more than
4 seconds with ignition switch on
- No.7 abs warning light stays on more than 4 seconds with ignition switch on
- No.8 brake system warning light stays on more than 4 seconds with ignition
switch on
- No.9 tcs off light stays on more than 4 seconds with ignition switch on
- No.10 tcs does not work correctly
- No.11 there is malfunction in the system even though abs warning light,
brake system warning light, tcs off light do not illuminte
- No.1 any of the following lights do not illuminate with ignition switch on:
(abs warning light, brake system warning light, dsc indicator light and/or
tcs-off light)
- No.2 any of the following lights stay on: (abs warning light, brake system
warning light, dsc indicator light and/or tcs-off light)
- No.3 there is a malfunction in the system even though abs warning light,
brake system warning light, dsc indicator light and tcs-off light do not
illuminate
- No.4 abs or tcs*1 operates frequently/tcs does not work correctly*1: dsc
system function contains traction control function, dsc indicator light goes on
and off while dsc operates
- No.5 dsc*2 operates frequently/dsc does not work correctly*2: dsc indicator
light goes on and off while dsc operates
Note
To warm up the engine completely, idle the engine and wait for
more than 5 minutes.
Diagnostic procedure
...
ABS (ABS/TCS)
DSC
FOREWORD
Before performing the steps in Symptom Troubleshooting, perform the
On-board Diagnostic Inspection. To check the DTC, follow the DTC Inspection
steps.
...
Other materials:
Mazda 6 Service Manual: Drive shaft (atx) disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Boot Band (Wheel Side) Disassembly Note
Note
The boot band does not need to be removed unless it is being replaced.
Remove the boot clamp with end clamp pliers as shown and discard the
cla ...
Mazda 6 Service Manual: Outside the United States/Canada
Government regulations in the United States/Canada require that automobiles meet
specific emission regulations and safety standards. Therefore, vehicles built for
use in the United States/Canada may differ from those sold in other countries.
The differences may make it difficult or even impossi ...