Mazda 6 Service Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on

Mazda 6 Service Manual / Braking system / Troubleshooting (abs/tcs/dynamic stability control) / No.7 abs warning light stays on more than 4 seconds with ignition switch on

Diagnostic procedure

When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunction. If there is a problem, check to make sure connectors, terminals and wiring harnesses are connected correctly and undamaged.

No.6 both abs warning light and brake system warning light stay on more than 4 seconds with ignition switch on

Diagnostic procedure ...

No.8 brake system warning light stays on more than 4 seconds with ignition switch on

Diagnostic procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact p ...

Other materials:

Mazda 6 Service Manual: Stabilizer control link inspection
1. Remove the stabilizer control link from the vehicle. 2. Inspect for bending and damage. 3. Measure the ball joint starting torque. (1) Rock the ball joint stud side to side 10 times. (2) Rotate the ball joint stud 10 times. (3) Measure the starting torque using a suitable allen so ...

Mazda 6 Service Manual: Steering angle sensor inspection
With DSC 1. Remove the column cover. (See COLUMN COVER REMOVAL/INSTALLATION) 2. Disconnect the steering angle sensor connector. 3. Connect battery positive voltage to terminal A and ground to terminal F of the steering angle sensor. 4. Turn the steering wheel to the right and left, and verify ...