DTCs Reading Procedure
1. Perform the necessary vehicle preparation and visual inspection.
2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure.
3. Retrieve DTCs by WDS or equivalent.
Pending Trouble Code Access Procedure
1. Perform the necessary vehicle preparation and visual inspection.
2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure.
3. Retrieve PENDING TROUBLE CODES
by WDS or equivalent.
Freeze Frame PID Data Access Procedure
1. Perform the necessary vehicle preparation and visual inspection.
2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure.
3. Record the FREEZE FRAME DATA by WDS or equivalent.
On-Board System Readiness Tests Access Procedure
1. Perform the necessary vehicle preparation and visual inspection.
2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure.
3. Monitor the OBD systems operating status by WDS or equivalent.
Diagnostic Monitoring Test Results Access Procedure
1. Perform the necessary vehicle preparation and visual inspection.
2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure.
3. Access to the DIAGNOSTIC MONITORING TEST RESULTS and read the test results by WDS or equivalent.
Mazda 6 Service Manual: Rear door lock actuator inspection
Door Lock Actuator
1. Disconnect the front door lock actuator connector.
2. Apply battery positive voltage to the front door lock actuator terminals
and inspect the operation of the front door lock actuator.
If not as specified, replace the front door lock actuator.
With double locking ...
Mazda 6 Service Manual: Engine disassembly/assembly
1. Disconnect the engine and automatic transaxle. (ATX) (See AUTOMATIC
TRANSAXLE REMOVAL/INSTALLATION.)
2. Disconnect the engine and manual transaxle. (MTX) (See MANUAL TRANSAXLE
REMOVAL/INSTALLATION.)
3. Remove the intake-air system. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
4. Remove ...