Note
Continuity Inspection
1. Inspect the following if the power steering is inoperative (See POWER STEERING FLUID INSPECTION.):
2. Disconnect the PSP switch connector.
3. Start the engine.
4. Inspect for continuity between the PSP switch terminal and GND using an ohmmeter.
Specification
Circuit Open Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following harness for open or short. (Continuity check)
Open circuit
- PSP switch terminal (harness-side) and PCM terminal 1Z (harness-side)
Short circuit
- PSP switch terminal (harness-side) and body GND
Mazda 6 Service Manual: Coil removal/installation
Note
Do not remove the coil unless you are replacing it.
When only the coil is replaced, the immobilizer system reprogram
procedure is not necessary.
1. Disconnect the negative battery cable.
2. Remove the column cover.
3. Remove in the order indicated in the table.
4. Install in ...
Mazda 6 Service Manual: Timing chain
TIMING CHAIN REMOVAL/INSTALLATION
Warning
Fuel vapor is hazardous. It can very easily ignite, causing
serious injury and damage. Always keep sparks and flames away from fuel.
Fuel line spills and leakage are dangerous. Fuel can ignite and
cause serious injures or death and damage. Fuel ...