Airflow Inspection
Note
1. Disconnect the negative battery cable.
2. Remove the purge solenoid valve. (See PURGE SOLENOID VALVE REMOVAL/INSTALLATION.)
3. Inspect airflow between the ports under the following conditions.
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See F43 PCM REMOVAL/INSTALLATION.)
2. Inspect the following wiring harness for open or short (continuity check).
Open circuit
- Purge solenoid valve terminal A (harness-side) and PCM terminal 4U
- Purge solenoid valve terminal B (harness-side) and main relay terminal C (harness-side)
Short circuit
- Purge solenoid valve terminal A (harness-side) and body GND
- Purge solenoid valve terminal B (harness-side) and power supply
Mazda 6 Service Manual: Radio Reception
AM characteristics
AM signals bend around such things as buildings or mountains and bounce off the
ionosphere.
Therefore, they can reach longer distances than FM signals.
Because of this, two stations may sometimes be picked up on the same frequency
at the same time.
FM characteristics
An ...
Mazda 6 Service Manual: Foreword
Outline
The OBD (on-board diagnostic) test inspects the integrity and function
of the headlight auto leveling system and output the results when reqested
by the specitic tests.
OBD test also:
- Provides a quick inspection of the headlight auto leveling system.
- Is usually perfor ...