Mazda 6 Service Manual: Rear map light inspection
1. Remove the rear map light. (See REAR MAP LIGHT REMOVAL/INSTALLATION.)
2. Inspect for continuity between the rear map light terminals using an ohmmeter.
- If not as specified, replace the rear map light.
Rear map light removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Rear Map Light Removal Note
1. Insert a tape-wrapped flathe ...
Cargo compartment light removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal. ...
Other materials:
Mazda 6 Service Manual: Schedule 1
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fill up, or replace if
necessary.
R: Replace
L: Lubricate
T: Tighten
Remarks:
*1 Use of FL-22 is recommended when replacing engine coolant. Using engine coolant
other than FL-22 may cause serious damage to the engine and cooli ...
Mazda 6 Service Manual: Actuator cable installation
1. Slide the lock lever in the direction shown by the arrow to unlock the
adjuster.
2. Turn the ratchet ring to release lock in the direction shown by the arrow.
3. Install the actuator cable to the cruise actuator.
Caution
Due to the possibility of actuator cable damage, make sure th ...