Mazda 6 Service Manual: Rear shock absorber removal/installation
Caution
- Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
Bracket Installation Note
Install the bracket as shown in the figure.
REAR SHOCK ABSORBER INSPECTION
Inspect the rear shock absorber in the same way as the front shock absorber. (See FRONT SHOCK ABSORBER INSPECTION.)
REAR SHOCK ABSORBER DISPOSAL
Dispose the rear shock absorber in the same way as the front shock absorber. (See FRONT SHOCK ABSORBER DISPOSAL.)
Rear suspension
...
Rear coil spring removal/installation
1. Remove the rear auto leveling sensor. (See REAR AUTO LEVELING SENSOR
REMOVAL/INSTALLATION.)
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
4. Adjust ...
Other materials:
Mazda 6 Service Manual: Washer fluid-level sensor inspection
1. Disconnect the negative battery cable.
2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION)
3. Insoect for continuity between the washer fluid-level sensor terminals
using an ohmmeter.
4. Verify that the windshield washer motor operates.
If not as specified, replace the ...
Mazda 6 Service Manual: Oil pump
OIL PUMP REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Drain the engine oil. (See ENGINE OIL REPLACEMENT.)
3. Remove the oil pan. (See OIL PAN REMOVAL/INSTALLATION.)
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Inspect the en ...