Mazda 6 Owners Manual: Filament repair
1. Use isopropyl alcohol to clean around the damaged section of the filament.
2. Attach tape above and below the damaged section of the filament.
3. Using a small brush or marking pen, repair the filament with silver paint
or equivalent.
4. After 2-3 minutes, carefully remove the tape without ...
Mazda 6 Owners Manual: No.7 abs warning light stays on more than 4 seconds with ignition switch on
Diagnostic procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there is a
problem, check to make sure conne ...