Mazda 6 Service Manual: Cruise actuator removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Cover Removal Note
Unclamp the clips of the heater hoses at the front of the cover.
Cruise actuator inspection
1. Disconnect the cruise actuator connector.
2. Measure the voltage, continuity and resistance at the cruise actuator
terminals as indicated below.
If not as specified, inspect the parts listed ...
Other materials:
Mazda 6 Service Manual: Operation
NOTE
The engine may not start and security indicator light may illuminate
or flash if the key is placed in an area where it is difficult for the system
to detect the signal, such as on the dashboard or in the glove compartment.
Move the key to a location within the signal range, switch ...
Mazda 6 Service Manual: Automatic transaxle removal/installation
1. Disconnect the negative battery cable.
2. Remove the battery and battery tray.
3. Remove the aircleaner component. (See INTAKE-AIR SYSTEM
REMOVAL/INSTALLATION.)
4. Remove the front tires and splash shield.
5. Remove the under cover.
6. Remove the steering gear and power steering pipe. (See ...