Mazda 6 Service Manual: Cruise control system

Rear antenna feeder inspection

1. Verify that there is no continuity between antenna feeder terminals A and B using an ohmmeter. 2. Inspect for continuity between the antenna feeder terminals using an ohmmeter. If not as ...

Cruise actuator removal/installation

1. Disconnect the negative battery cable. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Cover Removal Note Unclamp the clips of the heater hoses at ...

Other materials:

Mazda 6 Service Manual: Lane-Change Signals and Three-Flash Turn Signal
Lane-Change Signals Move the lever halfway toward the direction of the lane change—until the indicator flashes— and hold it there. It will return to the off position when released. Three-Flash Turn Signal After releasing the turn signal lever, the turn signal indicator flashes three times ...

Mazda 6 Service Manual: Climate control unit wire adjustment
Air Mix Wire 1. Set the temperature control dial at max cold. 2. Set the air mix link to max cold in the direction shown by the arrow and insert a screwdriver at the set hole. 3. Connect the air mix wire to air mix link. 4. Clamp the air mix wire to wire clamp. 5. Verify that the temperatur ...