Mazda 6 Service Manual: Dtc b1318

Mazda 6 Service Manual / Braking system / On-board diagnostic (dynamic stability control) / Dtc b1318

Caution

When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used.

Diagnostic procedure

Dsc on-board diagnosis

On-Board Diagnostic (OBD) Test Description (See ABS (ABS/TCS) ON-BOARD DIAGNOSIS) DTC Table PID/DATA Monitor Table Active Command Modes Table ...

Dtc b1342

Caution When attaching the tester lead to the DSC HU/CM connector the SST (49 G066 004) must be used. Diagnostic procedure ...

Other materials:

Mazda 6 Service Manual: Rear wiper motor removal/installation
1. Disconnect the negative battery cable. 2. Remove the rear wiper arm and blade. (See REAR WIPER ARM AND BLADE REMOVAL/INSTALLATION.) 3. Remove the liftgate lower trim. (See LIFTGATE LOWER TRIM REMOVAL/INSTALLATION) 4. Remove in the order indicated in the table. 5. Install in the revers ...

Mazda 6 Service Manual: Dtc table
DTCs are common for present and past malfunction diagnosis. Note When DTCs not shown in the DTC table are displayed, replace the SAS unit. If the air bag system warning light does not illuminate or remains illuminated when the ignition switch is turned to ON position, i ...