Mazda 6 Service Manual: Dtc p0768

Dtc p0767

Dtc p0771

Other materials:

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

Mazda 6 Service Manual: Center roof antenna removal/installation
1. Disconnect the negative battery cable. 2. Remove the headliner. (See HEADLINER REMOVAL/INSTALLATION.) 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 5. After installation, verify that the rubber of the center roof antenna is installed to the r ...