Mazda 6 manuals

Mazda 6 Service Manual: On-board diagnostic

Selector lever disassembly/assembly
1. Disassemble in the order shown in the figure. 2. Assemble in the reverse order of disassembly. Connector Disassembly Note 1. Insert a thin piece of metal from the terminal side of the connec ...

Foreword
When the customer reports a vehicle malfunction, check the malfunction indicator lamp (MIL), HOLD indicator light flashing, and PCM memory for diagnostic trouble code (DTC), then diagnose the ...

Other materials:

Mazda 6 Service Manual: General procedures
PRECAUTION (FRONT AND REAR AXLE) Wheel and Tire Removal/Installation 1. The removal and installation procedures for the wheels and tires are not mentioned in this section. When a wheel is removed, tighten it to 88-118 N·m {9.0-12.0 kgf·m, 65.0-87.0 ft·lbf} Brake Line Disconnection/Connecti ...

Mazda 6 Service Manual: Foreword
Caution When the engine does not start or stalls and the following DTCs are not indicated, go to engine symptom troubleshooting. Note When the immobilizer system is defective, the engine cannot be started. If engine condition is normal but light stays on, inspect for short circ ...

© 2016-2026 Copyright www.mazda6info.net