Mazda 6 Owners Manual: Flashing the Headlights
Can be used when the ignition is switched ON.
To flash the headlights, pull the lever fully towards you (the headlight switch does not need to be on).
The headlight high-beam indicator light in the instrument cluster illuminates simultaneously. The lever will return to the normal position when released.
Headlight High-Low Beam
The headlights switch between high and low beams by moving the lever forward
or backward.
When the headlight high-beams are on, the headlight high-beam indicator light
is turned on.
...
Coming Home Light
The coming home light turns on the headlights (low beams) when the lever is operated.
To turn on the lights
When the lever is pulled with the ignition switched to ACC or OFF, the low beam
headligh ...
Other materials:
Mazda 6 Owners Manual: Rear map light removal/installation
1. Disconnect the negative battery cable.
2. Remove in the order indicated in the table.
3. Install in the reverse order of removal.
Rear Map Light Removal Note
1. Insert a tape-wrapped flathead screwdriver into the gap between the
headliner and the rear map light.
2. Push the hooks to re ...
Mazda 6 Owners Manual: Base removal
1. Remove the rearview mirror.
2. Wind each end of a wire around a bar.
Warning
Using a SST (piano wire) with bare hands can cause injury. Always
wear gloves when using a SST (piano wire).
Note
Use a long sawing action to spread the work over the whole length
of the SST (piano w ...