Mazda 6 Service Manual: Front door glass removal/installation
1. Operate the front door glass so that the distance from the top of the front door glass to the upper part of the rear beltline molding is 210 mm {8.3 in}.
2. Disconnect the negative battery cable.
3. Remove the front door trim.
4. Remove the hole cover.
5. Remove the screws.
6. Insert your hand in hole of the front door unit, and lift out the front door glass.
7. Install in the reverse order of removal.
Door adjustment
1. Measure the gap and height between the front or rear door and the body.
2. If not as specified, loosen the front or rear door hinge installation
bolts or the door lock striker installation screw ...
Rear door glass removal/installation
1. Fully down the rear door glass.
2. Remove the rear door trim.
3. Remove the hole cover.
4. Pull up the rear door weatherstrip and remove the screw.
5. Remove the bolt.
6. Remove the glass run ...
Other materials:
Mazda 6 Service Manual: Headlight zeroset
Note
When the configuration is not set for the auto leveling control unit,
headlight zeroset cannot be executed.
1. Adjust the tire air pressure to the specification.
2. Position the unloaded vehicle on a flat, level surface.
3. Connect the SST (WDS or equivalent) to the DLC-2.
4. Turn t ...
Mazda 6 Service Manual: Battery Maintenance
To get the best service from a battery:
Keep it securely mounted.
Keep the top clean and dry.
Keep terminals and connections clean, tight, and coated with petroleum jelly
or terminal grease.
Rinse off spilled electrolyte immediately with a solution of water and baking
soda.
If th ...