Mazda 6 Service Manual: Door
- Front door structural view
- Rear door structural view
- Front door removal/installation
- Rear door removal/installation
- Door adjustment
- Front door glass removal/installation
- Rear door glass removal/installation
- Front door unit removal/installation
- Rear door unit removal/installation
- Front door latch and lock actuator removal/installation
- Rear door latch and lock actuator removal/installation
- Front door key cylinder removal/installation
- Front outer handle removal/installation
- Rear outer handle removal/installation
- Inner handle removal/installation
- Regulator handle removal
- Regulator handle installation
Front fender panel
FRONT FENDER PANEL REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the front side turn light.
3. Remove the fender molding. (See COWL GRILLE REMOVAL/INSTALLATION.)
4. Remo ...
Other materials:
Mazda 6 Service Manual: Trailing link removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-speed sensor (axle side) and fix it to an appropri ...
Mazda 6 Service Manual: No.3 passenger-side air bag cut-off indicator light does not illuminate
Diagnostic Procedure
When performing an asterisked (*) troubleshooting inspection, shake the
wiring harness and connectors while doing the inspection to discover whether
poor contact points are the cause of any intermittent malfunction. If there
is a problem, check to make sure connec ...