Mazda 6 Service Manual: Rear door removal/installation
Warning
- Handling the side air bag sensor improperly can accidentally deploy the side air bag module, which may seriously injure you. Read AIR BAG SYSTEM SERVICE WARNINGS before working around the B-pillar areas. (See SERVICE WARNINGS.)
Note
- The side air bag sensor is located in the B-pillar.
1. Disconnect the negative battery cable.
2. To remove the checker, turn the rear door speaker.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
5. Adjust the rear door. (See DOOR ADJUSTMENT.)
Front door removal/installation
1. Disconnect the negative battery cable.
2. To remove the front door hinge, remove the front fender panel.
3. To remove the checker, remove the door speaker.
4. Remove in the order indicated in th ...
Door adjustment
1. Measure the gap and height between the front or rear door and the body.
2. If not as specified, loosen the front or rear door hinge installation
bolts or the door lock striker installation screw ...
Other materials:
Mazda 6 Service Manual: Front shock absorber and spring removal/installation
Caution
Performing the following procedures without first removing the ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it
is pulled by mistake. Before performing the following procedures, remove the
ABS wheel-sensor (axle side) and fix it to an appropriate pl ...
Mazda 6 Service Manual: Dashboard Illumination
(Without auto-light control)
When the position lights are turned on with the ignition switched ON, the brightness
of the dashboard illumination is dimmed.
(With auto-light control)
When the position lights are turned on with the ignition switched ON, the brightness
of the dashboard illuminati ...