Mazda 6 Service Manual: On-board diagnostic [immobilizer system]

Dtc b2735

Diagnostic procedure ...

Foreword

Caution When the engine does not start or stalls and the following DTCs are not indicated, go to engine symptom troubleshooting. Note When the immobilizer system is defective, the engine ...

Other materials:

Mazda 6 Service Manual: Spark plug removal/installation
1. Disconnect the negative battery cable. 2. Remove the plug hoie plate. Lift off and remove the plug hole plate from the installation areas (rubber and clips) as shown in the figure. 3. Disconnect the high-tension lead. 4. Remove the spark plugs using the plug-wrench. 5. Install th ...

Mazda 6 Service Manual: Rear washer hose removal/installation
1. Disconnect the negative battery cable. 2. Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION) 3. Partially peel off the right side mud guard. 4. Remove rear washer hose No.1 from the clips. 5. Remove rear washer hose No.1 and joint pipe A. 6. Remove the A-pillar trim. (See A-PIL ...