Mazda 6 Service Manual: Window glass

Filament inspection

1. Turn the ignition switch to ON position. 2. Turn the rear window defroster switch on. Caution Directly touching the rear window defroster filament with the lead of the voltmeter will damag ...

Windshield removal

1. Remove the rearview mirror. 2. Remove the cowl grille. 3. Remove the headliner. 4. Apply protective tape along the edge of the body to protect it from damage. 5. Apply protective tape to the ...

Other materials:

Mazda 6 Service Manual: Seat warmer unit inspection
1. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION.) 2. Remove the seat cushion trim. 3. While inspecting for continuity between the terminals A and B of the connector, use a dryer to warm the thermostat of the seat warmer unit on seat cushion. 4. When the indication on the ohmm ...

Mazda 6 Service Manual: General procedures
PRECAUTION (CLUTCH) Clutch Pipe Removal/Installation Note A common reservoir is used for the clutch and brake system fluid. 1. If clutch pipes have been disconnected any time during the procedure, add clutch fluid (brake fluid), bleed the air, and inspect for leakage after the procedure ...