Mazda 6 Service Manual: Active command mode table

Pid/data monitor table

Dtc b1231

Other materials:

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

Mazda 6 Service Manual: Dsc hu/cm inspection
1. Remove the battery and battery bracket. 2. Disconnect the DSC HU/CM connector. 3. Connect the SST (49 G066 004) to the DSC HU/CM connector and harness side connector. 4. Inspect voltage referring the table below. Terminal Voltage Table (reference value) (Ignition switch is at ON, and conne ...