Mazda 6 Service Manual: Dtc b1231

Active command mode table

Dtc b1342

Other materials:

Mazda 6 Service Manual: Rear bumper removal/installation
1. Disconnect the negative battery cable. 2. Remove the rear combination light. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. Rear Bumper Removal Note Pull the rear bumper ends (wheel arch) outward to disengage with the bumper slider. Cautio ...

Mazda 6 Service Manual: On-board diagnostic test
DTCs Reading Procedure 1. Perform the necessary vehicle preparation and visual inspection. 2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located as shown in the figure. 3. Retrieve DTCs by WDS or equivalent. Pending Trouble Code Access Procedure 1. Perform the necessary ...