Mazda 6 manuals

Mazda 6 Service Manual: Air bag system

Troubleshooting Index



No.3 even when headlight switch is turned on, daytime screen does not change to night time screen. (front and rear combination lights operate normally.)
Diagnostic procedure ...

No.1 air bag system warning light does not illuminate
Diagnostic Procedure When performing an asterisked (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact point ...

Other materials:

Mazda 6 Service Manual: Transaxle fluid temperature (tft) sensor removal/installation
Warning When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before replacing the ATF. 1. Remove the oil pan. (See CONTROL VALVE BODY REMOVAL.) 2. Disconnect the TFT sensor connector. 3. Remove the TFT sensor. 4. Install a TFT senso ...

Mazda 6 Service Manual: Electrical troubleshooting tools
Jumper wire A jumper wire is used to create a temporary circuit. Connect the jumper wire between the terminals of a circuit to bypass a switch. Caution Do not connect a jumper wire from the power source line to a body ground. This may cause burning or other damage to wiring harnesse ...

© 2016-2026 Copyright www.mazda6info.net