Mazda 6 Service Manual: Air bleeding
1. Inspect the fluid level. (See POWER STEERING FLUID INSPECTION.)
2. Jack up the front of the vehicle and support it on safety stands.
3. Turn the steering wheel fully to the left and right several times with the engine not running.
4. Reinspect the fluid level.
- If it has dropped, add fluid.
5. Repeat Steps 3 and 4 until the fluid level stabilizes.
6. Lower the vehicle.
7. Start the engine and let it idle.
8. Turn the steering wheel fully to the left and right several times.
9. Verify that the fluid is not foamy and that the fluid level has not dropped.
- If the fluid level has dropped, add fluid as necessary and repeat Steps 8 and 9.
Power steering fluid inspection
Fluid Level Inspection
1. Inspect the power steering fluid level.
Add fluid to the specified level as necessary.
Fluid specification
ATF M-III or equivalent (e.g. Dexron®II)
Fluid Leakage I ...
Other materials:
Mazda 6 Service Manual: Rear brake (disc) removal/installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, depress the pedal several times, rotate the wheel by
hand, and verify that the brake does not drag.
Disc Pad Installation Note
1. Turn the manual adjustment gear counterclockwi ...
Mazda 6 Service Manual: No.9 noise while operating a/c system
Diagnostic procedure
* : If there is gas leakage, air enters into the A/C system. The desiccant
within the receiver/drier absorbs the moisture from the air and becomes
saturated. If the A/C system is used in this condition, the inside of the A/C
compressor will begin to rust due to this ...