Mazda 6 Service Manual: Steering system
- Location index
- General procedures
- Engine speed sensing power steering
- Air bleeding
- Power steering fluid inspection
- Steering wheel and column inspection
- Steering wheel and column removal/installation
- Steering shaft inspection
- Steering gear and linkage removal/installation
- Steering gear and linkage disassembly
- Steering gear and linkage inspection
- Steering gear and linkage assembly
- Power steering oil pump removal/installation
- Power steering oil pump disassembly/assembly
Drive shaft (mtx) disassembly/assembly
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
Clip Disassembly Note
1. Mark the drive shaft and outer ring for proper assembly.
Caution
...
Location index
STEERING LOCATION INDEX
...
Other materials:
Mazda 6 Service Manual: Throttle position (tp) sensor inspection
Note
Perform the following inspection only when directed.
Resistance Inspection
1. Perform the following test only when directed.
If as specified but TP PID value is out of specification, inspect
resistance of TP sensor.
If not as specified, inspect the following:
- Accelerato ...
Mazda 6 Service Manual: Variable tumble control system (vtcs) shutter valve actuator inspection
1. Remove the air hose. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION.)
2. Disconnect the vacuum hose from the VTCS shutter valve actuator.
3. Connect a vacuum pump to the VTCS shutter valve actuator.
4. Apply vacuum and verify that the rod moves.
If the rod dose not move, replace the intake ...