Mazda 6 manuals

Mazda 6 Service Manual: Power steering oil pump removal/installation

Mazda 6 Service Manual / Steering system / Engine speed sensing power steering / Power steering oil pump removal/installation

1. Remove in the order indicated in the table.

2. Install in the reverse order of removal.



Steering gear and linkage assembly
Caution Place copper plates, rag, or similar material in a vise, when secure the mounting bracket portion of the steering gear. Assemble in the order indicated in the table. Mounting Ru ...

Power steering oil pump disassembly/assembly
Note The following procedure is for replacement of the O-ring and oil seal only. Replace the pump component if other repairs are necessary. 1. Disassemble in the order indicated in the table ...

Other materials:

Mazda 6 Service Manual: Engine coolant temperature (ect) sensor removal/installation
Warning When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. 1. Drain the engine coolant. (See COOLING SYSTEM SERVICE WARNINGS.) 2. Disconnect the ECT sensor connector. 3. Remove the ECT sensor. 4. Install in the reve ...

Mazda 6 Service Manual: Fuel-filler lid and opener removal/installation
1. To remove the fuel-filler lid opener, remove the left side trunk side trim (4SD) or trunk side lower trim (5HB). 2. To remove the fuel-filler lid opener cable, perform the following and turn over the floor covering. (1) Remove the driver-side front seat. (2) Remove the driver-side fron ...

© 2016-2025 Copyright www.mazda6info.net