Mazda 6 manuals

Mazda 6 Service Manual: Bonnet adjustment

Mazda 6 Service Manual / Body / Bonnet / Bonnet adjustment

Gap Adjustment

1. Remove the front fender.

2. Loosen the bonnet hinge installation bolts and reposition the bonnet.


3. Tighten the bolts.

4. Verify that the gap between the bonnet and the body is within the specification.

Clearance
a: 2.5-4.5 mm {0.08-0.17 in}


Height Adjustment

1. Turn the stop rubber to adjust the height of the bonnet.



2. Verify that the height between the bonnet and the body is within the specification.


Clearance
a: 3.0-6.0 mm {0.12-0.23 in} b: 3.0-6.0 mm {0.12-0.23 in} c: -1.0-1.0 mm {-0.04-0.04 in}

Bonnet removal/installation
Warning Removing the bonnet without supporting can be dangerous. The bonnet may fall and injure you. Always perform the following procedure with at least another person. 1. Disconnect the ...

Front fender panel
FRONT FENDER PANEL REMOVAL/INSTALLATION 1. Disconnect the negative battery cable. 2. Remove the front side turn light. 3. Remove the fender molding. (See COWL GRILLE REMOVAL/INSTALLATION.) 4. Remo ...

Other materials:

Mazda 6 Service Manual: Control valve body installation
On-Vehicle Installation Caution Be sure to align the parking rod and the manual valve. 1. Install the accumulator springs and accumulators into the transaxle case. 2. Install the control valve body component. Tightening torque 7.8-10.8 N·m {80-110 kgf·cm, 70-95 in·lbf} Bo ...

Mazda 6 Service Manual: Constant Monitoring
The following components of the air bag systems are monitored by a diagnostic system: Crash sensors, and diagnostic module (SAS unit), Front air bag sensors Air bag modules Side crash sensors Air bag/Front seat belt pretensioner system warning light Front seat belt pretensioners Re ...

© 2016-2026 Copyright www.mazda6info.net